Skip to content
Version 1.0.0

Waves and trips

A driver does not do one long route a day. They go out, come back to the kitchen, load again and go out again. Routisserie calls each of those outings a trip, and groups trips into waves by meal.

Trips ​

A trip is one driver leaving the kitchen with a loaded vehicle, making a few stops in order, and coming back. Trips are what you see as cards on the plan board and on the driver's phone. A driver's trips are numbered in order through the day: the board shows trip 2, trip 3 after the driver's name.

Between two trips the driver needs time at the kitchen to reload (15 minutes unless the kitchen's setting says otherwise). Routisserie leaves that time when it plans a driver's next trip, and flags Trip overlap if a trip would start before the previous one is back.

Waves ​

A wave is one round of trips for a meal. There are four to start with:

WaveFood ready to loadTakes stops whose window startsDrive-time factor
Breakfast5:30 AM5:00 AM to 10:00 AM1.25
Lunch9:45 AM10:00 AM to 2:00 PM1.10
Afternoon1:30 PM2:00 PM to 5:00 PM1.20
Evening4:30 PM5:00 PM to midnight1.10
  • A stop goes into the wave whose range holds the start of its window. A stop with a window of 11:30 AM–12:00 PM is a Lunch stop. You can put a stop in another wave by hand (stop panel, Wave).
  • No trip of a wave leaves before its food ready time.
  • The drive-time factor stretches drive times for that part of the day (traffic). 1.25 means a 20-minute drive is planned as 25 minutes. The calibration report suggests better factors from real trips.

Admins and dispatchers change waves in Settings → Waves.

A driver's morning ​

One driver, two trips

The driver leaves the kitchen, delivers three breakfast stops and comes back. The kitchen needs 15 minutes to reload the vehicle. The lunch trip cannot leave before the lunch food is ready (the wave's Food ready time), so the driver waits. On the lunch trip, stop 2 arrives with less than 10 minutes of its window left ( at risk) and stop 3 arrives after its window ended ( late).

This is how the board's Timeline view shows the same idea: one row per driver, each stop a block from arrival to departure, the window as a thin bracket above it.

Shifts and vehicles ​

Each driver has a usual shift (for example 6:00 AM–6:00 PM) and a usual vehicle. The roster for a day can change both, or mark the driver as off. Optimize plans trips only for drivers who work that day, inside their hours, in the vehicle the roster gives them. Outside shift is flagged when a trip runs past a driver's hours.

A vehicle is either a company vehicle or a driver's personal car. Mileage driven in a personal car is reimbursed (see Reports → Mileage).

How long food may ride ​

Routisserie also watches how long a delivery is on board, from leaving the kitchen to arriving at the customer. More than 90 minutes is flagged as Long ride (an admin can change the limit).

Routisserie 1.0.0 · User's Guide